Handyman and Contracting Services in Bend, Redmond, La Pine & Madras, Oregon
Our handyman and contracting services in Bend and across Central Oregon cover the full build sequence: insulation and drywall, interior and exterior painting, demolition with roofing, siding, landscaping, tile and decking follow-on work, arboring, windows and doors, cabinets and appliances, ADA accessibility, custom framing, plumbing, concrete and stucco, HVAC duct work, flooring, electrical finish and underground, asphalt, and scheduled general maintenance for residential and commercial property.
Everything we build, repair and maintain
Service 01
Insulation and Drywall Installation
Central Oregon swings from single-digit winter nights to 90-degree summer afternoons, so an envelope that actually performs is the difference between a comfortable home and a punishing power bill. We install batt, blown-in and rigid board insulation to code-required R-values, air-seal every penetration, then hang, tape, mud, texture and sand drywall to a finish that reads flat under raking window light.
- Batt, blown-in attic and rigid foam board insulation
- Vapour barriers, air sealing and rim-joist detailing
- Hanging, taping and three-coat mud on walls and ceilings
- Knockdown, orange peel, smooth Level 5 and custom textures
- Water, smoke and settlement drywall repair patches
- Garage, shop and ADU insulation upgrades
Interior and Exterior Painting and Finish Work
Paint is the layer everybody sees and the layer that protects everything underneath it. Our painters prep the way old-school finish crews do: wash, scrape, sand, fill, caulk and prime before a single topcoat is rolled. On exteriors we specify UV-stable coatings that survive high-desert sun and freeze-thaw cycling; on interiors we mask, protect flooring and cut crisp lines at every ceiling and casing.
- Full interior repaints, accent walls and ceilings
- Exterior body, trim, soffit and fascia coatings
- Cabinet, door and millwork spray finishing
- Deck and fence staining, sealing and refresh
- Pressure washing, scraping and substrate prep
- Caulking, priming and stain-blocking on problem surfaces
Service 02
Service 03
Residential and Commercial Demolition
Good demolition is careful, not violent. We isolate utilities, protect the surfaces that stay, contain dust with poly and negative air, and salvage material worth keeping. Selective interior strip-outs, full structure tear-downs, exterior removals and site clearing are all handled with load-out, hauling and clean broom-swept turnover so the next trade can start the same week.
- Selective interior strip-out of kitchens, baths and offices
- Full structure and outbuilding tear-down
- Utility isolation, dust containment and debris hauling
- Load-out, sorting and responsible disposal or recycling
- Site clearing and pad preparation for the next build phase
- Post-demo clean and turnover ready for framing
These are not standalone service lines. They are the follow-on scopes we routinely perform once demolition opens a structure up, so the property is closed back in, weather-tight and finished by the same crew.
Roofing
Tear-off, decking repair, underlayment, shingle and metal roof installation, flashing, vents and leak correction.
Siding
Wood, metal, T1-11 tongue and groove, and Hardie board production siding with correct trim, house wrap and flashing.
Landscaping
Grading, xeriscape rock work, boulders, planting beds, edging, irrigation adjustment and clean site finishing.
Tile / Trim
Floor, wall and shower tile over waterproofed substrate, plus base, casing, crown and custom trim carpentry.
Decking and Tree Trash Removal
Deck build, repair and refinishing, plus removal and haul-away of tree debris, brush and yard waste.
Arboring, Tree Care and Canopy Management
Ponderosa and juniper make Central Oregon beautiful and, when they are neglected, dangerous. Our arboring work covers structural pruning, deadwood removal, crown thinning for wind resistance, defensible-space clearing around structures, sectional felling in tight yards, and stump grinding. Everything is rigged and lowered rather than dropped when a roof, fence or garden bed is in the way.
- Structural pruning, crown thinning and canopy raising
- Deadwood, storm damage and hazard limb removal
- Sectional felling and rigging in tight residential lots
- Defensible-space and wildfire fuel-reduction clearing
- Stump grinding and root-flare cleanup
- Chipping, hauling and green-waste disposal
Service 04
Service 05
Window and Door Installation and Replacement
A window is only as good as its flashing. We set new construction and retrofit units square, plumb and shimmed, then integrate sill pans, flashing tape and weather-resistive barrier so water leaves the wall instead of living in it. Doors get true reveals, adjusted strikes, weatherstrip that seals, and hardware that closes with a single quiet click.
- Retrofit and new-construction window replacement
- Sliding, French, patio and multi-slide door units
- Entry doors, storm doors and interior pre-hung doors
- Sill pans, flashing and weather-resistive barrier integration
- Interior and exterior casing, jamb extension and trim-out
- Hardware, lockset, threshold and weatherstrip installation
Cabinet and Appliance Installation
Cabinets expose every flaw in a wall, so we laser-level, scribe to the substrate and shim until doors and drawers line up across the whole run. Base, wall, tall and island boxes are fastened to structure, fillers are cut clean, and hardware is jig-drilled for consistent spacing. Appliances are set, levelled, connected and tested before we leave.
- Stock, semi-custom and custom cabinet installation
- Island, pantry and built-in storage assemblies
- Countertop coordination, scribing and support blocking
- Crown, light rail, toe kick and filler detailing
- Range, hood, dishwasher, microwave and refrigerator setting
- Soft-close hardware, pulls and drawer alignment
Service 06
Service 07
ADA and Handicap Accessibility Remodeling
Accessibility work should feel like design, not like equipment. We build ADA-conscious ramps at compliant slopes, widen doorways for clear passage, install curbless roll-in showers with proper drainage, and set grab bars into solid blocking rather than drywall anchors. Kitchens get lowered work surfaces and reachable storage so daily routines stay independent.
- Compliant entry ramps, landings and handrails
- Doorway widening and threshold levelling
- Curbless roll-in showers and accessible bathing
- Grab bars anchored into engineered blocking
- Comfort-height fixtures and lever hardware
- Lowered counters, reachable storage and clear turning radii
Custom Framing and Structural Carpentry
Every finish trade inherits the framer's mistakes, so we frame to the line. Walls, floor systems, roof structures, additions, dormers, load-bearing modifications with proper temporary shoring, and engineered beam installs are all built plumb, level and square with hardware installed exactly as the plan specifies.
- Wall, floor and roof framing for additions and new builds
- Load-bearing wall removal with engineered headers
- Beam, post, joist and truss installation
- Dormers, bump-outs, shops and detached structures
- Deck, pergola and covered-patio structural framing
- Sub-floor repair, sistering and structural correction
Service 08
Service 09
Plumbing: Rough-In, Finish, Underground and Sloan Valve Systems
We work the full plumbing arc: underground supply and drain lines, in-wall rough-in laid out to fixture dimensions, and finish trim that lands level and leak-free. Commercial restrooms get Sloan valve systems installed, rebuilt and tuned so flush volume stays correct and maintenance calls drop.
- Underground water service, sewer and drain line work
- Rough-in supply, DWV, venting and pressure testing
- Finish trim: sinks, tubs, toilets, valves and fixtures
- Sloan flushometer install, rebuild and diaphragm service
- Water heater replacement and re-pipe projects
- Hose bibs, shut-offs, laundry boxes and appliance lines
Concrete Flatwork and Stucco Application
Concrete in the high desert has to survive freeze-thaw, so we build the base properly: compacted subgrade, correct reinforcement, controlled water ratio, and joints cut before shrinkage decides where the crack goes. Stucco is applied in scratch, brown and finish coats over correct lath and moisture barrier for a wall assembly that breathes and sheds.
- Driveways, walkways, patios and equipment pads
- Footings, stem walls and structural slabs
- Broom, trowel, exposed aggregate and stamped finishes
- Three-coat stucco over lath and weather barrier
- Stucco patching, colour coat and texture matching
- Saw-cut control joints, sealing and crack repair
Service 10
Service 11
HVAC Systems, Heating, Cooling and Duct Work
Comfort is a system, not a box. We size equipment to the actual load, install furnaces, heat pumps, mini-splits and air handlers, then build or repair the duct network that carries the air. Leaky, undersized or crushed duct is the reason most homes have one freezing bedroom, and it is the first thing we measure.
- Furnace, heat pump and air handler installation
- Ductless mini-split systems for additions and shops
- Sheet-metal duct fabrication, runs and register placement
- Duct sealing, insulating and airflow balancing
- Thermostat, zoning and control upgrades
- Seasonal servicing, filtration and preventative maintenance
Flooring Installation and Sub-Floor Preparation
Flat sub-floor first, always. We check deflection, level with patch or self-levelling compound, install proper underlayment, then lay luxury vinyl plank, engineered wood, laminate, tile or carpet with correct expansion gaps and transitions. Baseboard, shoe and thresholds finish the room so nothing telegraphs later.
- Luxury vinyl plank, engineered hardwood and laminate
- Tile flooring with proper substrate and waterproofing
- Carpet and pad installation with clean seams
- Sub-floor levelling, patching and squeak correction
- Stair treads, risers, nosing and transitions
- Baseboard, shoe moulding and threshold finishing
Service 12
Service 13
Electrical Finish and Fixture Installation
Finish electrical is where a remodel starts to look expensive. Devices set flush and plumb, plates tight to the wall, recessed cans aligned across the ceiling grid, dimmers matched to the load, and every circuit labelled, tested and verified before energising. Small details, enormous perceived quality difference.
- Switch, outlet, GFCI and AFCI device trim-out
- Recessed can, pendant and chandelier hanging
- Ceiling fans, bath fans and exhaust venting
- Dimmers, smart switches and lighting controls
- Panel labelling, circuit testing and troubleshooting
- Exterior, landscape and security lighting
Underground Electrical and Conduit Work
Underground work has to be right the first time, because the second time involves an excavator. We locate before we dig, trench to required depth, sleeve and bed conduit properly, pull correctly sized conductors, install warning tape, and coordinate inspection before backfill and compaction.
- Trenching and conduit runs to code-required depth
- Service laterals and meter base feeds
- Sub-panel feeds to shops, garages and ADUs
- Well pump, irrigation and pump-house circuits
- Landscape, gate and outbuilding power runs
- Locates, inspection coordination and clean backfill
Service 14
Service 15
Asphalt Paving, Repair and Sealcoating
Asphalt fails from the bottom up. We build a compacted aggregate base, pave to a consistent mat thickness, roll while temperature is right, and grade so water runs off instead of standing. For existing surfaces we cut and patch failed sections, fill cracks, and sealcoat to slow oxidation.
- New asphalt driveways, aprons and approach paving
- Parking lot paving, overlay and resurfacing
- Cut-and-patch repair of alligatored or failed sections
- Crack filling, pothole repair and edge restoration
- Sealcoating and surface protection
- Grading, drainage correction and base preparation
General Maintenance for Homes and Commercial Property
Most property problems are cheap when they are small. Our maintenance programme handles the running list that never quite gets done: sticking doors, failing caulk, loose railings, dripping fixtures, damaged siding, gutter cleaning, seasonal checks, punch lists and tenant turnovers for landlords and property managers.
- Scheduled residential and commercial maintenance visits
- Punch lists, honey-do lists and small repairs
- Tenant turnover, make-ready and rental repairs
- Door adjustment, hardware and lock service
- Caulking, sealing, gutter and drainage upkeep
- Seasonal inspections and preventative fixes
Service 16
Tell us about the project. We will tell you what it really takes.
Call, text or send the form and a person who actually works on the tools will get back to you — usually the same business day.
Call or text
541-350-6996Hours
Mon–Sat, 7:00am – 6:00pm
Service area
Bend, La Pine, Redmond & Madras, OR
Request your free estimate
The more detail you give us, the more accurate the number.
Service questions we hear every week
Scope, sequencing and specialist trades — explained without the jargon.
Not sure which service you need?
Describe the problem and we will tell you which trade solves it, what it involves, and what it should cost.